HP LaserJet 4100 HP PCL/PJL reference (PCL 5 Printer Language) - Technical Ref - Page 191
Specifies the chord angle used to define the arc., degree angle is used.
View all HP LaserJet 4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
z Sweep Angle - Specifies in degrees the angle through which the arc is drawn. A positive angle draws the angle in the positive direction (angle of rotation - +X-axis to the +Y-axis); a negative angle draws the angle in the negative direction (+X-axis to the - Y-axis). (Note, the relation of the +X-axis to the +Y-axis/-Y-axis can change as a result of scaling point or scaling factor changes.) If a sweep angle greater than 360 degrees is specified, a 360-degree angle is used. z Chord Angle - Specifies the chord angle used to define the arc. The default is 5 degrees. Refer to the "Chord Angle" discussion in the Arc Absolute (AA) command discussion (Chapter 20) for information on setting the chord angle. Figure 21-27 EN WG, Fill Wedge 21-47
EN
WG, Fill Wedge
21-47
Sweep Angle
— Specifies in degrees the angle through which
the arc is drawn. A positive angle draws the angle in the positive
direction (angle of rotation - +X-axis to the +Y-axis); a negative
angle draws the angle in the negative direction (+X-axis to the –
Y-axis). (Note, the relation of the +X-axis to the +Y-axis/–Y-axis
can change as a result of scaling point or scaling factor changes.)
If a sweep angle greater than 360 degrees is specified, a
360-degree angle is used.
Chord Angle
— Specifies the chord angle used to define the arc.
The default is 5 degrees. Refer to the “Chord Angle” discussion in
the Arc Absolute (AA) command discussion (Chapter 20) for
information on setting the chord angle.
Figure 21-27