HP LaserJet 4100 HP PCL/PJL reference (PCL 5 Printer Language) - Technical Ref - Page 77

Table 19-15 Example: The IW Command (continued) SP1; Select pen number 1. Even though there is no physical pen, the SP command must be used to enable printing. SI.2,.35; Set Absolute Character Size to .2 x .35 cm. PA2000,3200; Specify absolute plotting and move to location (2000,3200) (plotter units). DT@,1; Define label terminator to be the "@" character, without printing the character. LBTHIS IS AN EXAMPLE Print a label beginning at (2000,3200). OF IW@; (The label on the left is shown on two lines -with a Carriage Return in the middle of the text- for convenience in this example. In an actual command sequence, this label text should be all on one line to print as shown in the plot at the end of this example.) IW3000,1300,4500,3700; Specify a soft-clip window (in plotter units). PD2000,1700 Pen Down; print a line from the current pen position to (2000,1700). Current pen position at start of command is at the letter W baseline. LBTHIS IS AN EXAMPLE Print the same label at (2000,1700). (This OF IW@; label should not contain carriage returns to print as shown in the plot for this example.) PU3000,1300; Pen Up and move to position (3000,1300). PD4500,1300,4500,3700; Pen Down and begin drawing box indicating the soft-clip window. PD3000,3700,3000,1300; Finish drawing the soft-clip window box PU; EC%0A ECE Pen Up Enter PCL Mode. Reset the printer to end the job and eject the page. EN IW, Input Window 19-31