HP Mini 1000 HP Mini 1000 NetBook - Maintenance and Service Guide - Page 43
Mass storage devices, and then detach the tape from the top of - hard drive removal
View all HP Mini 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Mass storage devices NOTE: Each hard drive spare part kit and solid-state drive spare part kit includes an FPC cable and bracket. Description 60-GB, 4200-rpm hard drive 8-GB solid-state drive 16-GB solid-state drive Spare part number 504601-001 507313-001 507314-001 Before removing the hard drive or solid-state drive, follow these steps: 1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the device. 3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the device. 4. Remove the battery (see Battery on page 30). 5. Remove the keyboard (see Keyboard on page 33). To remove the hard drive: 1. Release the ZIF connector (1) to which the USB board pass-through cable is attached. The cable lies across the top of the hard drive. 2. Disconnect the USB board pass-through cable (2), and then detach the tape from the top of the hard drive. 3. Release the low insertion force (LIF) connector (1) to which the hard drive cable is attached, and then disconnect the cable (2). 4. Remove the two silver Phillips PM2.0×6.0 screws (3) that secure the drive to the device. Component replacement procedures 35