HP NetServer LP 2000r Installing IBM OS/2 on an HP Netserver - Page 18

power user, it is OK to use the "Manual Process" to complete the installation. Phase 1: Create copy of IBM "Diskette 1" label it "Work Diskette 1" 1. Create the Drivers/Utilities diskette using the HP Navigator CD-ROM. Follow the steps described in "Section 2" of this document. 2. Create a copy of IBM "Diskette 1" and label it "Work Diskette 1". Follow the Step by Step procedure described in Section 2 of this document. Manual Process: You can also use a spare PC running DOS, OS/2 or NT to make a copy of the original IBM Diskette. Label your copy diskette "Work Diskette 1". Insert master IBM "Diskette 1" in drive A and enter the following command: DISKCOPY A: A: Phase 2: On "Work Diskette 1" update CONFIG.SYS and copy new drivers 3. Edit CONFIG.SYS on "Work Diskette 1" to add the HP SCSI and driver for disk array adapter if one is present. Follow the step-by-step procedure described in Section 2 of this document. Manual Process: You can also use a spare PC running DOS, OS/2 or NT to complete the following tasks. Please read "Consideration 1" in Section 1 of this document and complete the table in that section before you proceed with this step. A) If you have an HP DAC, add three lines to the start of CONFIG.SYS as follows: basedev=ibm1s506.add basedev=hpda.add basedev=aic7870.add If you have an HP NetRAID, add three lines to the start of CONFIG.SYS as follows: basedev=ibm1s506.add basedev=mraid.add basedev=aic7870.add B) While editing CONFIG.SYS locate and delete any lines that look like the one's you've 18