HP NetServer LP 2000r Installing IBM OS/2 on an HP Netserver - Page 31

IBM type 2 drivers, as follows: basedev=ibm2flpy.add basedev=ibm2adsk.add basedev=ibm2scsi.add Remark out those driver lines using the REM command, since they are not needed, so that they read as follows... REM basedev=ibm2flpy.add REM basedev=ibm2adsk.add REM basedev=ibm2scsi.add E) While editing the CONFIG.SYS file, locate the Adaptec drivers section with the following Adaptec driver lines: basedev=aha154x.add basedev=aha164x.add basedev=aha174x.add Remark out these lines by adding the REM command so they read as follows...(make sure you have no need for any of these drivers before implementing this step). rem basedev=aha154x.add rem basedev=aha164x.add rem basedev=aha174x.add 4. Copy required drivers to "Work Diskette 1" use a spare PC running DOS, OS/2, or NT to complete the following tasks: A) Create a temporary directory on the hard disk of the workstation you are using, by entering (if you created the C:\HPTEMP directory in step 13 of "Section 2" then skip the MD HPTEMP command): C: MD HPTEMP CD HPTEMP B) Insert the "Drivers/Utilities" diskette in drive A of the workstation, and enter the following copy commands: COPY A:\7800\AIC7870.ADD COPY A:\7700\AIC7770.ADD COPY A:\HPDA\HPDA.ADD COPY A:\NETRAID\MRAID.ADD 31