HP NetServer LP 2000r Installing IBM OS/2 on an HP Netserver - Page 37
Installing High Resolution Video Driver on a NetServer E 30, E 40
View all HP NetServer LP 2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
negotiate), 1 (for half), 2 (for full). [Example: FORCEDUPLEX = 2] SLOT: (required for multiple adapters, see TIP 9 in section one for instruction on obtaining the slot number) This parameter is optional if only one adapter is present. If it is specified but is incorrect, a message indicates that the value doesn't match the configuration but the driver finds the adapter and loads anyway. This parameter is required if more than one adapter is present in either one bus or multiple PCI buses of a system. The parameter tells the driver which adapter it controls. The SLOT number is the encoded value of the PCI adapter's device location. To determine the slot number, load the driver with only the DRIVERNAME parameter specified. The driver reports all the slots that have PCI adapter(s) installed. You can determine which card is in which slot by using SETUP.EXE (if you need to run this utility, you must create a J3171A/D5013A driver diskette from the Navigator diskette library section.) and matching the Ethernet addresses of the adapter to the device number specified in View Configuration. [Example: SLOT=0x1C] Alternate procedure to obtain the slot number: 1. Complete the configuration process but leave the slot field blank for each driver 2. Restart the system and record the list of slots that each driver displays 3. Complete the configuration by assigning one of the values from the list (without the 'ox') to the Slot parameter of each driver. Leave the field blank if you only have one adapter installed. Installing High Resolution Video Driver on a NetServer E 30, E 40, E 45 Note: It is critical that your system be set to VGA mode before starting this procedure. If you just installed the system using the procedure listed above then the system should be already set to VGA mode. Otherwise check your OS/2 manual on how to set the display to VGA. The video diskette contains a readme.txt file that you can print to use it as a reference documentation. You may want to look at that reference if you want to install many systems using a automatic script to install the video driver. 1. Insert the Cirrus Logic diskette into drive A: 2. Select the Diskette object on the launch pad to open the Drive A: 3. Double click on Install.exe. 4. Select "Install" from the Cirrus Logic Install Program. The display will show: Unpacking: filename... 5. Select OK to let Install identify your graphics hardware and memory configuration. 37