HP PSC 750 HP PSC 700 Series - (English) Macintosh User Guide - Page 16

HP PSC 700 Series Paper Tips Legal-size paper Even though the paper-length adjuster is fully extended, make sure that the input tray itself is pushed all the way in. Labels • Always use letter- or A4-size label sheets designed for use with (only works with HP inkjet products (like Avery Inkjet Labels), and make sure that printing) the labels are not over two years old. • Fan the stack of labels to make sure none of the pages are sticking together. • Place a stack of label sheets on top of standard paper in the input tray, print-side down. Do not insert labels one sheet at a time. Postcards Insert a stack of postcards with the print-side down into the input (only works with tray until it stops. Line the postcards up on the right side of the input printing) tray, slide the width adjuster up against the left side of the cards, and slide the length adjuster in until it stops. Continuous Continuous, banner paper is also known as computer or z-fold paper. (banner) paper • Before loading banner paper, remove all other paper from the (only works with input tray, and then raise the output tray above the catch on the printing) right side. 5DLVH WKH RXWSXW WUD\ DERYH WKH .DW.K RQ WKH ULJKW VLGH • If you use non-HP paper, use 20-lb. paper and fan the paper before loading it. • Verify that the stack of banner paper contains at least five pages in the stack. • Carefully tear off the perforated edge strips from both sides of the paper stack, if any, and unfold and refold the paper to make sure the pages do not stick together. • Put the paper in the input tray so that the unattached edge is at the top of the stack. Insert the first edge into the input tray until it stops, as shown in the figure above. 12 Chapter 4-Load paper or transparency film, or load originals