HP ProLiant ML330e Compaq ProLiant ML330e/ ML330 Server Maintenance and Servic - Page 30

Fan, Pull the fan out and away from the chassis

Get HP ProLiant ML330e PDF manuals and user guides View all HP ProLiant ML330e manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Removal and Replacement Procedures 2-17 Fan To remove the fan: 1. Complete the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the front bezel. See "Front Bezel" earlier in this chapter. 3. Remove the access panel. See "Access Panel" earlier in this chapter. 4. Disconnect the fan power cable from the system board fan connector . 5. Use a Phillips screwdriver to remove the four mounting screws from the rear of the server . 6. Pull the fan out and away from the chassis . 2 3 1 Figure 2-13. Removing the fan To replace the fan, reverse steps 2 through 6.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
Removal and Replacement Procedures
2-17
Fan
To remove the fan:
1. Complete the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2. Remove the front bezel. See
“
Front Bezel
”
earlier in this chapter.
3. Remove the access panel. See
“
Access Panel
”
earlier in this chapter.
4. Disconnect the fan power cable from the system board fan connector
.
5. Use a Phillips screwdriver to remove the four mounting screws from the rear of the
server
.
6. Pull the fan out and away from the chassis
.
1
2
3
Figure 2-13.
Removing the fan
To replace the fan, reverse steps 2 through 6.