HP ProLiant ML330e Compaq ProLiant ML330e/ ML330 Server Maintenance and Servic - Page 40
Server Feature Board, To remove a Server Feature Board
View all HP ProLiant ML330e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Removal and Replacement Procedures 2-27 Server Feature Board To remove a Server Feature Board: 1. Complete the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the front bezel. See "Front Bezel" earlier in this chapter. 3. Remove the access panel. See "Access Panel" earlier in this chapter. 4. Disconnect any cables connected to the Server Feature Board. 5. Remove the screw securing the Server Feature Board to the chassis , and then pull the Server Feature Board out of the server . 1 2 Figure 2-24. Removing the Server Feature Board NOTE: The Server Feature Board is located only in slot 3. To replace the Server Feature Board, reverse steps 2 through 5.
Removal and Replacement Procedures
2-27
Server Feature Board
To remove a Server Feature Board:
1. Complete the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2. Remove the front bezel. See
“
Front Bezel
”
earlier in this chapter.
3. Remove the access panel. See
“
Access Panel
”
earlier in this chapter.
4. Disconnect any cables connected to the Server Feature Board.
5. Remove the screw securing the Server Feature Board to the chassis
, and then pull the
Server Feature Board out of the server
.
1
2
Figure 2-24.
Removing the Server Feature Board
NOTE:
The Server Feature Board is located only in slot 3.
To replace the Server Feature Board, reverse steps 2 through 5.