HP ProLiant ML330e Compaq ProLiant ML330e/ ML330 Server Maintenance and Servic - Page 42
System Board
View all HP ProLiant ML330e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Removal and Replacement Procedures 2-29 System Board CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly grounded (earthed) before beginning any installation procedure. See "Electrostatic Discharge Information" earlier in this chapter for more information. To remove the system board: 1. Complete the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the front bezel. See "Front Bezel" earlier in this chapter. 3. Remove the access panel. See "Access Panel" earlier in this chapter. 4. Remove all expansion boards seated on the system board. 5. Disconnect all cables from the system board. 6. Remove the ten screws securing the system board to the chassis . 7. Pull the system board out of the chassis . 2 1 Figure 2-26. Removing the system board To replace the system board, reverse steps 2 through 7.