HP ProOne 600 Maintenance & Service Guide HP ProOne 600 G1 All-in-One - Page 106
Advanced, Device Options, LVDS Panel Select
View all HP ProOne 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
14. Disconnect the display cable from the display panel by pressing in on the tabs (1) on the side of the connector, and pulling the cable from the connector (2). Be sure to correctly position the jumpers on the converter board for the installed display panel, as follows: CAUTION: Incorrect jumper placement can result in damage to the converter board and display panel. To install a display panel, reverse the removal procedures. If you install a display panel from a different manufacturer than what was previously installed (for example, replace an LG panel with a Samsung panel), you need to update BIOS with the new panel information. Failure to do so may cause the new panel to function incorrectly. To update BIOS with the new panel model information: 1. Boot the computer. 2. Repeatedly press F10 when the monitor light turns green to access the F10 Setup utility. 3. Select Advanced, select Device Options, select LVDS Panel Select, and then select the manufacturer for the new display panel. 4. Save your settings, exit F10 Setup, and allow the computer to continue to the operating system. When you change the LVDS setting to the installed panel type, the BIOS reprograms the EDID with the correct data. You must set the panel before the Auto-select setting functions correctly. 96 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis