HP ProOne 600 Maintenance & Service Guide HP ProOne 600 G1 All-in-One - Page 71
Heat sink – Graphics board and processor, Graphics heat sink, To remove the heat sink
View all HP ProOne 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Heat sink - Graphics board and processor Description Heat sink for use with graphics board Heat sink for use with processor Spare part number 698214-001 698201-001 Separate heat sinks cool the discrete graphic board (select models only) and the processor. If installed, you must remove the smaller graphics heat sink before you can remove the larger processor heat sink. The graphics heat sink is secured with three Torx screws - two captured, one not captured. The heat sinks share the one non-captured screw. The processor heat sink is secured with five Torx screws - four captured, one shared, not captured. Graphics heat sink To remove the heat sink: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 33). 2. Remove the center access panel (see Access panel on page 37). 3. Remove the black Torx screw from the top of the heat sink (1). Heat sink - Graphics board and processor 61