HP ProOne 600 Maintenance & Service Guide HP ProOne 600 G1 All-in-One - Page 58
The optical drive data cable connects to the SATA3 and SATA PWR3 system board connectors.
View all HP ProOne 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
The optical drive data cable connects to the SATA3 and SATA PWR3 system board connectors. NOTE: The drive bracket is not spared. When replacing an optical drive, remove the bracket from the old drive and install it on the new drive. 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 33). 2. Remove the access panel (see Access panel on page 37). 3. Lift the tab at the back of the optical disc drive enclosure to release the drive. NOTE: When replacing an optical drive, remove the bracket from the old drive and install it on the new drive. The bracket is not spared. 48 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis
The optical drive data cable connects to the SATA3 and SATA PWR3 system board connectors.
NOTE:
The drive bracket is not spared. When replacing an optical drive, remove the bracket from
the old drive and install it on the new drive.
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer
on page
33
).
2.
Remove the access panel (see
Access panel
on page
37
).
3.
Lift the tab at the back of the optical disc drive enclosure to release the drive.
NOTE:
When replacing an optical drive, remove the bracket from the old drive and install it on
the new drive. The bracket is not spared.
48
Chapter 5
Removal and Replacement Procedures All-in One (AIO) Chassis