HP ProOne 600 Maintenance & Service Guide HP ProOne 600 G1 All-in-One - Page 76
mSATA Solid-State Drive
View all HP ProOne 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
mSATA Solid-State Drive The mSATA SSD is located on the bottom of the system board. The drive is secured with two Phillips screws. NOTE: In the following image, the mSATA SSD is not shown. To remove the mSATA SSD: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 33). 2. Remove the access panel (see Access panel on page 37). 3. Remove the two Phillips screws that secure the SSD to the computer. 4. Lift the SSD to a 45-degree angle, and then pull it away to remove it from the socket. To install the mSATA SSD, reverse the removal procedures. NOTE: mSATA SSD are designed with a notch to prevent incorrect insertion. 66 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis
mSATA Solid-State Drive
The mSATA SSD is located on the bottom of the system board. The drive is secured with two Phillips
screws.
NOTE:
In the following image, the mSATA SSD is not shown.
To remove the mSATA SSD:
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer
on page
33
).
2.
Remove the access panel (see
Access panel
on page
37
).
3.
Remove the two Phillips screws that secure the SSD to the computer.
4.
Lift the SSD to a 45-degree angle, and then pull it away to remove it from the socket.
To install the mSATA SSD, reverse the removal procedures.
NOTE:
mSATA SSD are designed with a notch to prevent incorrect insertion.
66
Chapter 5
Removal and Replacement Procedures All-in One (AIO) Chassis