HP StorageWorks 8/40 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 363
HIL-1107, Message, Probable Cause, Recommended, Action, Severity, tempShow, fanShow
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 363 highlights
38 HIL-1107 HIL-1107 Message , [HIL-1107], ,, ERROR, , Switch faulted, ()above threshold. Probable Cause Indicates that the switch voltage is above threshold. This message is specific to nonbladed switches and is not applicable to the Brocade 24000 or 48000. Recommended Action For the Brocade 200E, 3250, 3850, 4012, 4016, 4018, 4020, and 4024, the entire switch must be replaced because these switches do not have field-replaceable units (FRUs). For the Brocade 3900, replace the motherboard FRU. For the Brocade 4100, 4900, 7500, and AP7600, if the 12 volt level is faulty, replace one or both power supplies; if any other voltage is faulty, replace the entire switch. Severity ERROR HIL-1108 Message , [HIL-1108], , FFDC, CRITICAL, , Switch faulted, () below threshold. System preparing for reset. Probable Cause Indicates that the switch voltage is below threshold. This message is specific to nonbladed switches and is not applicable to the Brocade 24000 or 48000. Recommended Action For the Brocade 200E, 3250, 3850, 4012, 4016, 4018, 4020, and 4024, the entire switch must be replaced because these switches do not have field-replaceable units (FRUs). For the Brocade 3900, replace the motherboard FRU. For the Brocade 4100, 4900, 7500, and AP7600, if the 12 volt level is faulty, replace one or both power supplies; if any other voltage is faulty, replace the entire switch. Severity CRITICAL HIL-1201 Message , [HIL-1201], ,, WARNING< , Blower , speed ( RPM) above threshold. Probable Cause Indicates that the fan speed (in RPMs) has risen above the maximum threshold. A high speed does not necessarily mean that the fan is faulty. Recommended Action Run the tempShow command to verify that the switch temperatures are within operational ranges. Refer to the hardware reference manual for the temperature range of your switch. Make sure that the area is well-ventilated and that the room temperature is within operational range of your switch. Refer to the hardware reference manual for your switch for the operational temperature range. Run the fanShow command to monitor the speed of the fan generating this error. Fabric OS Message Reference 305 53-1001157-01