HP StorageWorks 8/40 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 545
SULB System Messages, SULB-1001
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 545 highlights
Chapter SULB System Messages 80 SULB-1001 Message , [SULB-1001], , AUDIT, WARNING, , Firmwaredownload command has started. Probable Cause Indicates the firmwareDownload command has been entered. This process should take approximately 17 minutes. The process is set to time out after 30 minutes. Recommended Action Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload command to continue without disruption. Do not fail over or power down the system during firmware upgrade. No action is required. Run the firmwareDownloadStatus command for more information. Severity WARNING SULB-1002 Message , [SULB-1002],, AUDIT, INFO, , Firmwaredownload command has completed successfully. Probable Cause Indicates the firmwareDownload command has completed successfully and switch firmware has been updated. Recommended Action No action is required. The firmwareDownload command has completed as expected. Run the firmwareDownloadStatus command for more information. Run the firmwareShow command to verify the firmware versions. Severity INFO SULB-1003 Message , [SULB-1003], , AUDIT, INFO, , Firmwarecommit has started. Probable Cause Indicates that the firmwareCommit command has been entered. Recommended No action is required. Run the firmwareDownloadStatus command for more information. Action Severity INFO Fabric OS Message Reference 487 53-1001157-01