HP TouchSmart 610-1150xt Getting Started (For 3D Models Only) - Page 24

Using 3D Cinema Technology

Get HP TouchSmart 610-1150xt PDF manuals and user guides View all HP TouchSmart 610-1150xt manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Component (1) Battery compartment NOTE: The battery is preinstalled and may have a protective tab. If the tab is attached, pull the tab to remove it. (2) Nose pieces (3) NOTE: There are 3 nose pieces in different sizes. One nose piece is installed on the glasses at the factory and two additional nose pieces ship with the glasses. Turning the 3D glasses on and off Your 3D glasses are easy to use: ● The 3D glasses turn on and off automatically. There is no on or off switch. ● When 3D content begins to play, the glasses detect an IR signal from the computer and turn on automatically. ● Once the 3D content begins to play, the lenses may appear to darken and you may see some flickering as the glasses begin to turn on. ● The battery installed in the glasses provides approximately 150 hours of 3D viewing time. To help conserve battery power, the glasses enter Standby if no IR signal is detected for 5 seconds. Using 3D Cinema Technology After you set up your 3D computer, you are ready to verify that you can properly view the 3D content. NOTE: The stereoscopic 3D effect works best in a darkened room. For optimal 3D viewing, the screen brightness controls are also disabled when watching 3D content. 1. To access 3D content, do one of the following: 20 Chapter 4 Using HP 3D Cinema Technology Getting Started

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
Component
(1)
Battery compartment
NOTE:
The battery is preinstalled and may have a protective tab. If the tab is attached,
pull the tab to remove it.
(2)
Nose pieces (3)
NOTE:
There are 3 nose pieces in different sizes. One nose piece is installed on the
glasses at the factory and two additional nose pieces ship with the glasses.
Turning the 3D glasses on and off
Your 3D glasses are easy to use:
●
The 3D glasses turn on and off automatically. There is no on or off switch.
●
When 3D content begins to play, the glasses detect an IR signal from the
computer and turn on automatically.
●
Once the 3D content begins to play, the lenses may appear to darken and
you may see some flickering as the glasses begin to turn on.
●
The battery installed in the glasses provides approximately 150 hours of 3D
viewing time. To help conserve battery power, the glasses enter Standby if
no IR signal is detected for 5 seconds.
Using 3D Cinema Technology
After you set up your 3D computer, you are ready to verify that you can properly
view the 3D content.
NOTE:
The stereoscopic 3D effect works best in a darkened room. For optimal
3D viewing, the screen brightness controls are also disabled when watching 3D
content.
1.
To access 3D content, do one of the following:
20
Chapter 4
Using HP 3D Cinema Technology
Getting Started