HP Visualize c3000 hp Visualize b1000 and c3000 workstations owner's guide (a5 - Page 105
Closing the System Unit After Propping Up the Power Supply
View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Changing Your Computer Hardware Configuration System Unit Power Supply Closing the System Unit After Propping Up the Power Supply Once you complete the task you set out to perform, you are ready to close the system unit. To close the system unit follow these steps: 1. Pull slightly back on the power supply until you are able to remove the bail from the bail lock. Using the power supply handle lower it downward into its original operating position. See Figure 5-3. 2. Tighten both captive screws in place as seen in Figure 5-3. Use a T-15 Torx driver and 6 inch-pounds of torque to tighten the screws. 3. Replace the left side panel of the system unit as shown in the section "Closing the Left Side Panel of the System Unit" in this chapter. Chapter 5 105