HP Visualize c3000 hp Visualize b1000 and c3000 workstations owner's guide (a5 - Page 143
Inserting the Hard Disk Drive
![]() |
View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Changing Your Computer Hardware Configuration Hard Disk Drives Figure 5-39 4. Insert the T-15 Torx Hard Disk Mounting Screws through the rubber mounting grommets and into the screw holes located on the sides of the hard disk drive. See Figure 5-39. You should tighten these screws using 6 inch-pounds of torque. Note that in order to screw the T-15 Torx screws into the sides of the hard disk drive you will have to have a T-15 Torx driver that is long enough to fit through the access holes on the sides of the hard disk drive bracket. Inserting the Hard Disk Drive T-15 Torx Shoulder Screw (there are four of them) Mounting Grommet (do not remove) Hard Disk Drive Bracket Hard Disk Drive Mounting Screw Access Hole (there are four of them) Hard Disk Drive 5. Slide the assembly into its hard drive slot, and push inward on the release lever until the front of the hard disk drive bracket is flush with the system unit and the lever snaps closed. The front panel should now be replaced as explained in the section "Closing the System Unit Front Panel" in this chapter. Chapter 5 143
![](/manual_guide/products/hewlettpackard-visualize-b1000-hp-visualize-b1000-c3000-workstations-owners-guide-a599290000-b0051bf/143.png)