HP Visualize c3000 hp Visualize b1000 and c3000 workstations owner's guide (a5 - Page 141
Installing a Hard Disk Drive
View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Changing Your Computer Hardware Configuration Hard Disk Drives Installing a Hard Disk Drive This procedure explains how to install your hard disk drive in the slot that has been preassigned SCSI ID 5. On internal hard disk drives, the slot determines the addressing. There are no cables required when installing a hard disk drive. Note that to install the hard disk drive, your computer must be turned off. NOTE If you are installing a hard disk drive, you will need to mount it and create a file system on it. This should be done after you have installed the hard disk drive. To mount a hard disk drive and create a file system on it use the procedure provided in the section "Adding a Hard Disk Drive as a File System Using SAM" found in this chapter. Figure 5-37 1. Open the front panel of your system unit using the instructions found in the section "Opening the System Unit Front Panel." In the lower-right corner of the system unit as you face it, there are two hard drive slots. The slot on the right is the one discussed in this section. See Figure 5-37. The Hard Drive Slots Hard Disk Drive Slots Chapter 5 SCSI ID 5 SCSI ID 6 141