HP Visualize c3000 hp Visualize b1000 and c3000 workstations owner's guide (a5 - Page 117
Installing the CD Drive
View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Changing Your Computer Hardware Configuration Removable Media Devices Figure 5-14 5. Remove the CD drive from its shipping container and check to see that the jumper on the back of the CD drive is set to the C Select position. Using the four blank filler screws (T-10 Torx/slotted screws) that were just removed, mount the disk drive to the bracket as shown in Figure 5-14. The screws should be tightened using 6 inch-pounds of torque. Note that the CD drive should extend approximately one inch out from the front of the CD drive bracket. Installing the CD Drive CD Drive Bracket Guide CD Drive Blank Filler Screws Bracket Screws 6. Slide the CD drive and its bracket into the system unit chassis as shown in Figure 5-14. There are runners on the side of each bracket and guides inside the CD drive chassis that will help the assembly to slide into place. Chapter 5 117