HP Visualize c3000 hp Visualize b1000 and c3000 workstations owner's guide (a5 - Page 185
Setting the Monitor Type with SAM
View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
The Boot Console Interface Displaying and Setting the Monitor Type To set the monitor type for GRAPHICS(2) to monitor type 1, type the following at the command prompt and press Enter: Configuration Menu: Enter command> monitor graphics(2) 1 This will take effect on the next reboot or reset of the system. MONITOR INFORMATION Path Slot Head HPA Resolution Freq Type Class GRAPHICS(2) 2 1 fffa000000 1280x1024 75Hz 1 PCI Configuration Menu: Enter command> The boot console displays a message that tells you that your new monitor selection will take effect the next time you reboot your system. The boot console also displays the new monitor information. Trying to change the monitor type to a number not listed for that graphics device fails and gives you the following warning message: Value of monitor type n out of range (n - nn) Trying to change the monitor type on an empty slot fails and gives you the following warning message: No such graphics card. Setting the Monitor Type with SAM The System Administration Manager (SAM) allows you to change the monitor type after the HP-UX 10.20 or 11.0 operating system release have been installed and running on your system unit. This section provides a brief explanation on how to set the monitor type using SAM. Note that you will need to be logged in as root to run SAM. Here are the steps for setting your monitor type with SAM: 1. Log in as root. 2. Move the mouse pointer to the Application Manager control for Chapter 6 185