HP rp3440 Internal Cabling Guide for HP Smart Array Controllers - Page 17
Single Partition Configuration,
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Cabling for the HP Integrity rx7620 Server Recabling for RAID Recabling for RAID From the factory, the internal hot plug drives for the HP Integrity rx7620 server are connected to the integrated SCSI card as follows (when viewed from the front of the server): • The top left hard drive has a SCSI connector cabled to the management processor (MP) card • The top right hard drive has a SCSI connector cabled to the Core I/O slot 8 cell 1 • The bottom left and right hard drive has a SCSI connector cabled to internal SCSI cell 0 To use RAID with your hot plug drives, you must disconnect the internal SCSI cables from their embedded controller and use the Cable kit (A7027-63001). Then follow the appropriate set of instructions given below. Single Partition Configuration Figure 2-3 shows the correct cabling for a single partition configuration, as viewed from the front of the server. Figure 2-3 Smart Array 6402 or 6404 Controller Card with Single Partition Cabling Chapter 2 13