HP rp3440 Internal Cabling Guide for HP Smart Array Controllers - Page 49
Removing the Fans, Lifting the Fan Power Bridge
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Cabling for the HP Integrity rx2620 and rx2600 Servers Recabling for RAID Step 2. To remove a fan, grasp the fan module with your index finger and thumb and lift it out of its slot. Note that each of the modules has indentations for grasping them with your index finger and thumb. See Figure 5-10. Figure 5-10 Removing the Fans Step 3. To remove a SCSI cable, lift up on the fan power bridge as shown in Figure 5-11. Figure 5-11 Lifting the Fan Power Bridge Step 4. Unplug one or both of the SCSI cables connected to the hard drive backplane (see Figure 5-7), depending upon whether you want to use one or both channels of the HP Smart Array controller card: • Single channel: unplug backplane SCSI cable Channel A (bottom) connector • Dual channel: unplug backplane SCSI cable Channel A (bottom) and SCSI cable Channel B (top) connectors Step 5. Disconnect the power cables and any LAN or telecommunications cables from the back of the server. Chapter 5 45