HP rp3440 Internal Cabling Guide for HP Smart Array Controllers - Page 50
Removing the Power Connectors, Disconnecting the iLO Manageability Card
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Cabling for the HP Integrity rx2620 and rx2600 Servers Recabling for RAID Step 6. Use a T-15 torx driver to unscrew the two power connector mounting screws and remove the power connectors from the back of the system. See Figure 5-12. Figure 5-12 Removing the Power Connectors Step 7. Disconnect the iLO Manageability card connector (orange) as shown in Figure 5-13. Figure 5-13Disconnecting the iLO Manageability Card Connector Step 8. Remove the two screws holding the iLO Manageability Card to the system board. The screws are located on the far left and right sides of the card when viewed from the back of the server chassis. Step 9. Remove the two connector-screws for the 25-Pin Management Port located on the right end of the card (holding it against the back of the server chassis). Step 10. Remove the card by grasping it by the edges and pulling it out (see Figure 5-14). Place the card on the anti-static bag that the controller card came in. Figure 5-14 Removing the iLO Manageability Card 46 Chapter 5