HP rp3440 Internal Cabling Guide for HP Smart Array Controllers - Page 52

Dual Channel RAID Cabling from a Controller Card Installed in

Get HP rp3440 PDF manuals and user guides View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Cabling for the HP Integrity rx2620 and rx2600 Servers Recabling for RAID Figure 5-16 Single Channel RAID Cabling from a Controller Card Installed in the PCI Cage Figure 5-17 Dual Channel RAID Cabling from a Controller Card Installed in the PCI Cage Step 13. Replace the PCI cage board cover, routing the RAID cable out of the cover's cable channel (see Figure 5-18). Note that the cable should be folded down flush against the controller card, with the latter half of the cable bent in order to exit through the cover's cable channel (see Item 1 in Figure 5-18). Figure 5-18 RAID Cable Routing Through the PCI Cage Board Cover 1 Step 14. Place the PCI cage back into the system. The RAID cable(s) must be flush against the server chassis as they exit the PCI cage cable channel (see Item 1 in Figure 5-19). They must be routed around the chassis side of fan 3 to the hard drive backplane (see Item 2 in Figure 5-19) to avoid crimping. 48 Chapter 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Cabling for the HP Integrity rx2620 and rx2600 Servers
Recabling for RAID
Chapter 5
48
Figure 5-16 Single Channel RAID Cabling from a Controller Card Installed in
the PCI Cage
Figure 5-17 Dual Channel RAID Cabling from a Controller Card Installed in the
PCI Cage
Step 13.
Replace the PCI cage board cover, routing the RAID cable out of the cover's cable channel (see
Figure 5-18). Note that the cable should be folded down flush against the controller card, with the
latter half of the cable bent in order to exit through the cover’s cable channel (see Item 1 in
Figure 5-18).
Figure 5-18 RAID Cable Routing Through the PCI Cage Board Cover
Step 14.
Place the PCI cage back into the system. The RAID cable(s) must be flush against the server
chassis as they exit the PCI cage cable channel (see Item 1 in Figure 5-19). They must be routed
around the chassis side of fan 3 to the hard drive backplane (see Item 2 in Figure 5-19) to avoid
crimping.
1