HP rp3440 Internal Cabling Guide for HP Smart Array Controllers - Page 7

Recabling for RAID, Single Partition Configuration

Get HP rp3440 PDF manuals and user guides View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Cabling for the HP Integrity rx8620 Server Recabling for RAID Recabling for RAID From the factory, the internal hot plug drives for the HP Integrity rx8620 server are connected to the integrated SCSI card as follows (when viewed from the front of the server): • The top left hard drive has a SCSI connector cabled to the internal SCSI cell 0 • The top right hard drive has a SCSI connector cabled to the internal SCSI cell 0 • The bottom left hard drive has a SCSI connector cabled to the internal SCSI cell 1 • The bottom right hard drive has a SCSI connector cabled to the internal SCSI cell 1 To use RAID with your hot plug drives, you must disconnect the internal SCSI cables from their embedded controller and use the Cable kit (A7027-63001). Follow the appropriate set of instructions given below. Single Partition Configuration Figure 1-4 shows the correct cabling for a single partition configuration, as viewed from the front of the server. Figure 1-4 Smart Array 5302 or 5304 Controller Card with Single Partition Cabling Chapter 1 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
Cabling for the HP Integrity rx8620 Server
Recabling for RAID
Chapter 1
3
Recabling for RAID
From the factory, the internal hot plug drives for the HP Integrity rx8620 server are connected to the
integrated SCSI card as follows (when viewed from the front of the server):
•
The top left hard drive has a SCSI connector cabled to the internal SCSI cell 0
•
The top right hard drive has a SCSI connector cabled to the internal SCSI cell 0
•
The bottom left hard drive has a SCSI connector cabled to the internal SCSI cell 1
•
The bottom right hard drive has a SCSI connector cabled to the internal SCSI cell 1
To use RAID with your hot plug drives, you must disconnect the internal SCSI cables from their embedded
controller and use the Cable kit (A7027-63001). Follow the appropriate set of instructions given below.
Single Partition Configuration
Figure 1-4 shows the correct cabling for a single partition configuration, as viewed from the front of the
server.
Figure 1-4
Smart Array 5302 or 5304 Controller Card with Single Partition Cabling