Hitachi NT65MA3 Instruction Manual - Page 8

5-5. Nail Driving Force Figure 3 shows by type of wood and nail the nailer output energy provided by the supply pressure and the nailing energy required for driving the nail flush. Air pressure which exceeds the intersecting point between the nailer output energy and the required nailing energy for driving the nail allows the nail to be fully driven. For example, when driving a nail of 1.8 mm dia. x 65 mm length (.072" x 2-1/2") into six sheets of 12 mm (.472") plywood (72 mm (2-27/32") thick) with the Model NT 65MA3, a pressure of about 6.3 bar (6.4 kgf/cm2, 91 psi) allows the nailer to drive the nail flush with the wood surface. A pressure beyond this value causes the nail head to be driven below the wood surface. Figure 3 should be used as a reference only because those values vary depending on the type of wood, moisture content, and grain of wood. Required nailing energy Nailer output energy Plywood (12 mm (.472") thick) x 6 P S NT 65MA NT 65MA2 NT 65MA3 NT65MA3 Fig. 3 Required nailing energy and nailer output energy 5-6. Optional Accessories Full sequential actuation mechanism kit (sequential trip mechanism kit) (Code No. 884320) A full sequential actuation mechanism kit (sequential trip mechanism kit) is provided as an optional accessory for the Model NT 65MA3. By using this optional accessory, a nail is driven by pressing the pushing lever first against a workpiece and then pulling the trigger (single-shot operation), and no nail is driven when pulling the trigger first and then pressing the pushing lever against a workpiece. Please recommend the full sequential actuation mechanism kit (sequential trip mechanism kit) to the customers who want to use it. Salespersons must instruct the customers to read the Handling Instructions attached to the full sequential actuation mechanism kit (sequential trip mechanism kit) and also the Handling Instructions of the Model NT 65MA3 thoroughly for correct use. --- 5 ---