Honeywell HJC5000 User Guide - Page 34
Step 2: Con the Controller for VideoBloX Mode
View all Honeywell HJC5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Installing UltraKey Lite with VideoBloX Figure 3-4 VideoBloX RJ45 to DB9 Male Adapter for VideoBloX and VideoBloX Lite CPUs RJ45 to DB9 male adapter Controller Serial Port RJ45 network cable Figure 3-5 VideoBloX Direct RJ45 Serial Port Connection for VideoBloX NetCPUs Controller RJ45 network cable Serial Port Figure 3-6 VideoBloX Serial Port RS422 Connection Example VB master: 1--RS422_TX - 2--RS422_TX + 3--RS422_RX + 4--RS422_RX - 5--GND VIdeoBlox Master Connections VideoBloX Serial Port (RS422) RJ45 define: 1--RS485_2+/RS422_2_TX+/ RS422_1_RX+ 2--RS485_2-/RS422_2_TX-/ RS422_1_RX3-NC 4--RS232RX 5--RS232GND 6--RS232TX 7--RS485_1-/RS422_1_TX8--RS485_1+/RS422_1_TX+ *RS485_2/RS422_2_TX and RS232 use same UART_AC 5 RJ45 to DB9 Male PI NOUT 5 RJ45 1 RJ45 Network Cable DB9 3 PSU TX+ TX- GND RX- RX+ #1 #2 #5 #7 #8 #2 #1 #5 #4 #3 5 RJ45 to DB9 Male 1 RJ45 Network Cable 3 PSU Controller 1 Controller 32 Step 2: Configure the Controller for VideoBloX Mode Note The controller factory defaults are VideoBloX mode, Address 1, baud rate 19200 bps. If any other mode has been selected then use the following steps to select VideoBloX mode. Otherwise skip to Step 3: Configure Address, Baud Rate or IP for VideoBloX Mode, page 35. 34