Honeywell HJC5000 User Guide - Page 44

Step 3B: Con the Controller for an Ethernet Connection, Serial Port1 Settings, Baud Rate, Parity

Get Honeywell HJC5000 PDF manuals and user guides View all Honeywell HJC5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

Installing UltraKey Lite with VideoBloX 2. Under Serial Port1 Settings, select the following from each drop-down list as required: • Baud Rate: 1200, 9600, 19200 or 57600 bps. The default for VideoBloX is 19200. • Parity: none • Stop Bits: 1 bit • Data Bits: 8 bits • Serial Mode: RS422 3. Click Apply to save the configuration, Cancel to exit without saving, or Default to restore all factory default values. Figure 3-11 Serial Port Configuration Tab Step 3B: Configure the Controller for an Ethernet Connection 1. From the side menu, click IP Configuration. See Figure 3-12. 2. In each of the fields, enter IP address, subnet mask, gateway and DNS values. 3. Click Apply to save the configuration, Cancel to exit without saving, or Default to restore all factory default values. Figure 3-12 IP Configuration Tab 44

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
44
Installing UltraKey Lite with VideoBloX
2.
Under
Serial Port1 Settings
, select the following from each drop-down list as
required:
•
Baud Rate
: 1200, 9600, 19200 or 57600 bps.
The default for VideoBloX is 19200.
•
Parity
: none
•
Stop Bits
: 1 bit
•
Data Bits
: 8 bits
•
Serial Mode
: RS422
3.
Click
Apply
to save the configuration,
Cancel
to exit without saving, or
Default
to
restore all factory default values.
Figure 3-11
Serial Port Configuration Tab
Step 3B: Configure the Controller for an Ethernet Connection
1.
From the side menu, click
IP Configuration
. See
Figure 3-12
.
2.
In each of the fields, enter
IP address
,
subnet mask
,
gateway
and
DNS
values.
3.
Click
Apply
to save the configuration,
Cancel
to exit without saving, or
Default
to
restore all factory default values.
Figure 3-12
IP Configuration Tab