Honeywell HJK7000 User Guide - Page 31
Installing and Configuring a Serial Connection
View all Honeywell HJK7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
UltraKey Plus Controller Installation and User Guide Installing and Configuring a Serial Connection Step 1: Connect to the UltraKey Plus Using the Serial Port Note Use only COM1 when in VideoBloX mode. See Table 2-1 below. Table 2-1 Serial Port COM1 Serial Port COM1 and COM2 Pin Assignments Type Pin RS422 1 2 5 7 8 RS485 7 8 Signal RX + RX GND TX TX + T/R T/R + Note For a list of accessories see Shipping Checklist on page 18. For port connections see UltraKey Plus Port Connections and Descriptions on page 19. To connect to the UltraKey Plus using the serial port: 1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it into place. See Figure 2-2. 2. Plug the AC adapter into the controller power port and the adapter into a power source. 3. Connect an RJ45 network cable to the controller serial port. 4. Connect the RJ45 network cable to VideoBloX: • For backwards compatibility with VideoBloX and VideoBloX Lite CPUs, an RJ45 to DB9 male adapter is required and included with your shipment. See Figure 2-3. • For VideoBloX NetCPU, the installation is a direct connection with the RJ45 network cable, also included. See Figure 2-4 and Figure 2-5. Document 800-02573 Rev B 31 11/2009