Honeywell HJK7000 User Guide - Page 52
Step 3A: Con the Controller for a Serial Port Connection, MAXPRO Configuration Tab
View all Honeywell HJK7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Installing UltraKey Plus with MAXPRO-Net Figure 3-11 MAXPRO Configuration Tab Step 3A: Configure the Controller for a Serial Port Connection To configure the controller for a serial port connection: 1. From the side menu Settings:Hardware Config, click Port Settings. See Figure 3-12. 2. Under COM1 Settings, select the following from each drop down list as required: • Baud Rate: 1200, 1800, 2400, 4800, 9600, 19200 or 57600 bps • Parity: none, even, or odd • Stop Bits: 1 bit or 2 bits • Data Bits: 7 bits or 8 bits • Serial Mode: RS422 3. If required, repeat step 2 for COM2 Settings to select RS232. 4. Click Apply to save the configuration, Cancel to exit without saving, or Default to restore all factory default values. 52
52
Installing UltraKey Plus with MAXPRO-Net
Figure 3-11
MAXPRO Configuration Tab
Step 3A: Configure the Controller for a Serial Port Connection
To configure the controller for a serial port connection:
1.
From the side menu
Settings:Hardware Config
, click
Port Settings
. See
Figure 3-12
.
2.
Under
COM1 Settings
, select the following from each drop down list as required:
•
Baud Rate
:
1200
,
1800
,
2400
,
4800
,
9600
,
19200
or
57600
bps
•
Parity
:
none
,
even
, or
odd
•
Stop Bits
:
1 bit
or
2 bits
•
Data Bits
:
7 bits
or
8 bits
•
Serial Mode
:
RS422
3.
If required, repeat
step 2
for
COM2 Settings
to select
RS232
.
4.
Click
Apply
to save the configuration,
Cancel
to exit without saving, or
Default
to
restore all factory default values.