Home » Husqvarna Manuals » Lawn Mowers » Husqvarna AUTOMOWER 535 AWD » Manual Viewer

Husqvarna AUTOMOWER 535 AWD Owner Manual - Page 39

To install the rear top cover, Battery, Winter service

View all Husqvarna AUTOMOWER 535 AWD manuals

Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

5.4.4 To install the rear top cover 1. Put the top cover on the rear body. WARNING: Use only original batteries recommended by the manufacturer. Product safety cannot be guaranteed with other batteries. Do not use nonrechargeable batteries. CAUTION: The battery must be charged fully before winter storage. If the battery is not fully charged it can be damaged and in certain cases be rendered useless. 2. Put the top cover in position (A) and push the 2 magnets to assemble the top cover (B). A B The charging time can vary depending on, among other factors, the ambient temperature. Below indicates that the battery is getting old and eventually needs replacing: • The operating time for the product is shorter than normal between charges. This leads to more charging cycles than normal, which increases the risk of tracks forming near the charging station. • The product is frequently found standing out on the lawn with Empty battery message. This indicates that the product does not have battery capacity enough to find the charging station. The battery is fine as long as the product maintains a well-cut lawn. Note: Battery life is dependent on the length of the season and how many hours a day the product is operating. A long season or many hours of use a day means that the battery must be replaced more regularly. 5.5 Battery WARNING: Only charge the product using a charging station and power supply which is intended for it. Incorrect use may result in electric shock, overheating or leakage of corrosive liquid from the battery. In the event of leakage of electrolyte flush with water and seek medical help if it comes in contact with the eyes etc. Contact your local Husqvarna representative to replace the battery. 5.6 Winter service Take your product to your Husqvarna central service for service prior to winter storage. Regular winter service will maintain the product in good condition and create the best conditions for a new season without any disruptions. Service usually includes the following: • Thorough cleaning of the body, the chassis, the blade disc and all other moving parts. 1427 - 002 - 20.12.2019 Maintenance - 39

Section	Page
Contents	2
Introduction	3
Support	3
Product description	3
Mowing technique	3
Find the charging station	3
Automower® Connect	3
Product overview	4
Symbols on the product	5
Symbols on the battery	6
General safety instructions	6
Menu structure overview 1	7
Menu structure overview 2	8
Menu structure overview 3	9
LED status indicator	10
Safety	11
IMPORTANT. READ CAREFULLY BEFORE USE. KEEP FOR FUTURE REFERENCE	11
Safety definitions	12
Safety instructions for operation	12
Use	12
Battery safety	13
How to lift and move the product	14
Maintenance	14
In the event of a thunderstorm	15
Installation	16
Introduction - Installation	16
Main components for installation	16
General preparations	16
Before the installation of the wires	16
To examine where to put the charging station	16
To examine where to put the power supply	17
To examine where to put the boundary wire	17
To put the boundary wire in a slope	19
Passages	19
To make an island	19
To make a secondary area	20
To examine where to put the guide wire	21
Work area examples	21
Installation of the product	21
Installation tools	21
To install the charging station	22
To install the boundary wire	23
To install the guide wire	23
To put the wire into position with stakes	24
To bury the boundary wire or the guide wire	24
To extend the boundary wire or the guide wire	24
After the installation of the product	25
To do a visual check of the charging station	25
Automower® Connect	25
To install the Automower® Connect app	25
To pair Automower® Connect and the product	25
My mowers	25
Firmware over the air (FOTA)	25
To set the Firmware over the air (FOTA)	25
Automower® Direct	25
To start to use Automower® Direct	26
User interface overview	26
To start the product for the first time	26
Settings in Automower® Connect	27
Schedule	27
To edit the schedule settings	27
To add a new schedule setting	27
To calculate the schedule setting	27
Operation	27
Weather timer	27
To set the Weather timer	28
ECO mode	28
To set the ECO mode	28
Installation	28
To find the charging station	28
To change the signal range of the charging station	28
To set the delay time for the guide wire and the boundary wire	28
Lawn coverage	29
To set the GPS function	29
To set the Lawn Coverage function	29
To measure the distance from the charging station	29
To do a test of the Lawn Coverage function	29
Drive Past Wire	29
To set the Drive past wire	30
Starting point	30
To set the starting point	30
Accessories	30
To avoid collisions with the mower house	30
General (Bluetooth® only)	30
Time & date	30
To set the time & date	30
Reset to factory settings	30
To reset to factory settings	30
Security (Bluetooth® only)	30
New loop signal	30
To create a New loop signal	31
To change the PIN code	31
Theft protection	31
Alarm duration	31
STOP button pressed	31
Carried away	31
To set the Theft protection	31
GeoFence	31
To set the center position for the GeoFence function	31
Automower® Connect (Bluetooth® only)	31
Messages	31
Operation	32
To switch on the product	32
Operating modes	32
Main area	32
Secondary area (2nd area)	32
Park	32
Park until further notice	32
Park for a selected number of hours	33
To stop the product	33
To switch off the product	33
To charge the battery	33
To adjust the cutting height with Automower® Connect	33
Maintenance	35
Introduction - maintenance	35
Clean the product	35
To clean the blade disc	35
Chassis	36
Wheels	36
The body of the product	36
Charging station	36
Replace the blades	36
To replace the blades	36
To replace the top covers	37
To remove the front top cover	37
To install the front top cover	37
To remove the rear top cover	38
To install the rear top cover	39
Battery	39
Winter service	39
Troubleshooting	41
Introduction - troubleshooting	41
Fault messages	41
Information messages	48
Indicator lamp in the charging station	49
Symptoms	50
Find breaks in the loop wire	51
Transportation, storage and disposal	54
Transportation	54
Storage	54
Disposal	54
To remove the battery	54
Technical data	56
Technical data	56
Registered trademarks	58
Warranty	59
Warranty terms	59
Applicable to US/CA market	60
Supplier's Declaration of Conformity	60

Match case Limit results 1 per page

5.4.4 To install the rear top cover

Put the top cover on the rear body.

Put the top cover in position (A) and push

the 2 magnets to assemble the top cover

(B).

5.5 Battery

WARNING:

Only charge the product

using a charging station and power

supply which is intended for it.

Incorrect use may result in electric

shock, overheating or leakage of

corrosive liquid from the battery. In the

event of leakage of electrolyte flush

with water and seek medical help if it

comes in contact with the eyes etc.

WARNING:

Use only original batteries

recommended by the manufacturer.

Product safety cannot be guaranteed

with other batteries. Do not use non-

rechargeable batteries.

CAUTION:

The battery must be

charged fully before winter storage. If

the battery is not fully charged it can

be damaged and in certain cases be

rendered useless.

The charging time can vary depending on,

among other factors, the ambient temperature.

Below indicates that the battery is getting old and

eventually needs replacing:

•

The operating time for the product is shorter

than normal between charges. This leads to

more charging cycles than normal, which

increases the risk of tracks forming near the

charging station.

•

The product is frequently found standing out

on the lawn with

Empty battery

message.

This indicates that the product does not

have battery capacity enough to find the

charging station.

The battery is fine as long as the product

maintains a well-cut lawn.

Note:

Battery life is dependent on the length of

the season and how many hours a day the

product is operating. A long season or many

hours of use a day means that the battery must

be replaced more regularly.

Contact your local Husqvarna representative to

replace the battery.

5.6 Winter service

Take your product to your Husqvarna central

service for service prior to winter storage.

Regular winter service will maintain the product in

good condition and create the best conditions for

a new season without any disruptions.

Service usually includes the following:

•

Thorough cleaning of the body, the chassis,

the blade disc and all other moving parts.

1427 - 002 - 20.12.2019

Maintenance -