Husqvarna AUTOMOWER 535 AWD Owner Manual - Page 42
Find breaks in the, loop wire
View all Husqvarna AUTOMOWER 535 AWD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
confirmed on the product. Contact your local Husqvarna representative if the same message appears often. For more information, refer to Messages on page 31. Message Cause Action No loop signal The power supply or the voltage cable are not connected. Examine the LED status on the charging station. If the LED is not lit, it indicates that there is no power. Examine the wall socket connection and whether an earth-fault breaker has tripped. Make sure that the low voltage cable is connected to the charging station. The power supply or low voltage cable Replace the power supply or low volt- are damaged. age cable. The boundary wire is not connected to the charging station. Make sure that the boundary wire connectors are fitted properly to the charging station. Replace connectors if damaged. Refer to To install the charging station on page 22. The boundary wire is broken. ECO mode is activated and the product has attempted to start outside the charging station. Check the signal given by the LED on the charging station. If the LED indicates break in the boundary wire, find out where the break is. Replace the damaged section of the loop with a new loop wire and splice using an original coupler. Refer to Find breaks in the loop wire on page 51. Put the product in the charging station. Start the product and close the hatch. The pairing between the product and the charging station is lost. Put the product in the charging station and generate a new loop signal. Refer to To create a New loop signal on page 31. The boundary wire is crossed on its way to and from an island. Make sure that the boundary wire is installed correctly. Refer to To install the boundary wire on page 23. Wheel motor blocked Disturbances from metal objects (fen- Move the boundary wire and/or make ces, reinforcement steel) or buried ca- more islands in the work area to in- bles. crease the signal strength. Grass or other object has wrapped around the drive wheel. Examine the drive wheel and remove the grass or other object. Wheel drive problem 42 - Troubleshooting 1427 - 002 - 20.12.2019