Husqvarna AUTOMOWER 535 AWD Owner Manual - Page 46

Message Cause Action Connectivity problem Problem with the Automower® Connect module. Restart the product. If the problem remains, the message requires action by authorized service technician. Outside work area The boundary wire connections to the charging station are crossed. Make sure that the boundary wire is connected correctly. Refer to To examine where to put the boundary wire on page 17. The boundary wire is too close to the edge of the work area. The work area slopes too much by the boundary loop. Make sure that the boundary wire has been laid according to the instructions. Refer to To install the boundary wire on page 23. The boundary wire is laid in the wrong direction around an island. Disturbances from metal objects (fences, reinforcement steel) or buried cables close by. Move the boundary wire and/or make more islands in the work area to increase the signal strength. The product finds it hard to distinguish Put the product in the charging station the signal from another product installa- and generate a new loop signal. Refer tion close by. to To create a New loop signal on page 31. Limited cutting height Unexpected cutting height Cutting height problem, drive The cutting height adjustment cannot move. Examine the cutting height adjustment and remove grass and other unwanted material. If the problem remains, the message requires action by authorized service technician. Cutting height blocked Cutting height problem No power in charg- Wrong or faulty power supply unit. ing station Examine the power supply. If it is necessary, replace the power supply. Power failure. Find and rectify the cause of the power failure. No contact between the contact plates Make sure that the charging plates and and the charging plates. the contact plates are connected. Cutting system im- Too few or too many blades. balance Examine the blades on the blade disc. 46 - Troubleshooting 1427 - 002 - 20.12.2019