IBM 86626RY Hardware Maintenance Manual - Page 117
Logical drive migration administration, Change RAID levels
UPC - 087944501879
View all IBM 86626RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
After the Rebuild operation completes, you can unblock the RAID level-0 logical drives and access them once again. But remember, the logical drive might contain damaged data. You must either re-create, install, or restore the data from the most recent backup disk or tape. To unblock a blocked drive: 1. Select the blocked logical drive from the Main screen of the Administration and Monitoring Program. 2. Select Unblock to unblock the drive. 3. Initialize all unblocked logical drives before using them. See "Initializing logical drives" on page 107. 4. Restore the data to the drive from the most recent backup disk or tape. Logical drive migration administration: The logical drive migration (LDM) feature dynamically changes the current logical drive structure. You can use this procedure to change the RAID level, increase the free space in a disk array, or change the size of a logical drive. To use the LDM feature, you must have at least two logical drives available: one free (FRE) logical drive and one source logical drive that is in the okay (OKY) state. During the LDM procedure, the ServeRAID adapter or controller changes the state of the FRE logical drive to SYS; then, temporarily uses the SYS drive to perform the migration. When the migration procedure completes, the ServeRAID adapter or controller changes the state of the SYS drive back to FRE. Change RAID levels: You can change (migrate) the RAID levels of currently defined logical drives. To use the Change RAID Level feature, all of the logical drives within the array must be the same RAID level. The ServeRAID adapters and controllers support changing RAID levels as follows: Change two-drive RAID level-0 to RAID level-5 by adding one hard disk drive Change two-drive RAID level-1 to RAID level-5 by adding one hard disk drive Change from RAID level-5 to RAID level-0 by removing one hard disk drive To change the RAID level of an existing disk array: Note If you are migrating to RAID level-0, the last drive defined in the array becomes RDY. Netfinity 5500 M20 - Type 8662 109