IBM 86626RY Hardware Maintenance Manual - Page 152
IBM ServeRAID Device Drivers for SCO Operating, Systems Diskette, IBM ServeRAID Device Drivers
UPC - 087944501879
View all IBM 86626RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Installing the files for OpenServer: Before you begin the installation, review the following information: You must install logical drives as Bus Number 0 when using the MKDEV program, regardless of the channel that the physical drives are on. You must install nondisk devices, such as CD-ROM and tape drives, as Bus Numbers 1, 2, or 3 relative to the channel to which they are attached. External Channel 1 connector is Bus Number 1, external Channel 2 connector is Bus Number 2, and internal Channel 3 connector is Bus Number 3. To configure the default nondisk devices during the initial installation: 1. Redefine the default tape drive in the initial bootstring. For example, to install the IPSRAID BTLD and redefine the tape drive, go to the BOOT prompt and type: link Stp=ips( , 1, 2, ) The numbers in parentheses represent the Host Adapter Number, the Bus Number, the SCSI ID, and the LUN respectively. 2. When prompted for the location of the installation CD, change the Bus Number and SCSI ID, as required. Adding BTLD at boot time: To install the ServeRAID device driver for OpenServer, Version 5.0.X: 1. Use the ServerGuide Diskette Factory to create an IBM ServeRAID Device Drivers for SCO Operating Systems Diskette. 2. At the BOOT prompt, type: link 3. Press Enter; then, when asked for the name of the package to load, type: ipsraid 4. Press Enter. 5. After the kernel loads but before it runs, link prompts you to insert the IBM ServeRAID Device Drivers for SCO Operating Systems Diskette. While the installation program copies the files, one or both of the following messages might appear: Messages 1. Extracting BTLD distribution for ipsraid... /etc/uadmin getdev b ips: No such device (error 19) 2. dynamic linker: dlvr_audit: Cannot open /dev/zero for file /lib/libprot.so.1 You can ignore Message A, no action is required. But if Message B appears, you must press Enter when prompted to continue the installation. 144 Netfinity Server HMM