IBM 86626RY Hardware Maintenance Manual - Page 40

Save settings: After you make configuration changes, review them to be sure that they contain the correct information. If the information is correct, select Save Settings to save the selected changes. Restore settings: After you make configuration changes, review them to be sure that they contain the correct information. If the information is incorrect, or if you do not want to save these changes, select Restore Settings to delete the changes and restore the previous settings. Load default settings: If you make configuration changes and then decide that you want to use default values instead, select Load Default Settings to cancel the changes and restore the factory settings. Exit setup: Select to exit from the Configuration/Setup Utility program. If you have made any changes, you will be asked if you want to make the changes or exit without making the changes. Configuring options Before installing a new device or program, read the documentation that comes with it. Reading the instructions helps you to determine the steps that are required for installation and configuration. The following list provides a preview of the actions that might be required to configure the server. 1. Run the Configuration/Setup Utility program and record the current configuration settings. See "Configuration/Setup Utility program" on page 21. 2. Set jumpers or switches on the server system board. See "Changing jumper positions" on page 176 and "System board jumpers" on page 280. 3. Set jumpers or switches on the device. See the instructions that came with the adapter. 4. Install the adapter in the server. See "Adapters" on page 161. 5. Install software programs. See the installation instructions that came with the software. 6. Resolve configuration conflicts. See "Resolving configuration conflicts" on page 33. 32 Netfinity Server HMM