IBM 8835 Hardware Maintenance Manual - Page 42
Attention
UPC - 000435158314
View all IBM 8835 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
5. On the rear panel, press the expansion-slot clip together to unlock the clip; then, pull the clip out from the server until it stops and rotate the clip as shown in the following illustration. It remains loosely attached to the server. Adapter retention bracket Alignment tab Expansionslot clip (adapter slot 1) Power-cord module Expansionslot clip (adapter slot 2) Retention clip Attention: Avoid touching the components and gold-edge connectors on the adapter. Ensure that the adapter is completely and correctly seated in the slot. Incomplete insertion might cause damage to the system board or to the adapter. 6. Remove the expansion slot cover from the slot. 7. To gain access to PCI-X slot 1, remove the PCI riser card from its connector (see "Riser card" on page 61). Riser card System board 8. To gain access to PCI-X slot 2, remove the power-cord module. a. Press down on the retention clip at the front of the power-cord module and slide the module toward the front of the server until the alignment tab is free of the slot on the side of the server. 32 325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide Eserver