IBM 8835 Hardware Maintenance Manual - Page 81
reassembling
UPC - 000435158314
View all IBM 8835 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
System board screws (7 places) Heat-sink retainer bracket screws (4 places) I/O port screws (4 places) Heat-sink retainer bracket screws (4 places) Locator hole Locator pin 15. Remove the six I/O port screws at the rear of the server. 16. Remove the eight screws that secure the two heat-sink retention modules to the system board. These eight screws also secure the system board to the chassis. 17. Remove the remaining seven screws on the system board that secure the system board to the chassis. 18. Carefully pull the board out of the server, taking special care not to disturb any surrounding components. To reinstall the board, place it carefully into position and ensure the locator pin engages the locator hole in the system board. Reverse steps 5 on page 70 through 14 on page 70 to replace the components that were removed. Note: When reassembling the components in the server, be sure to route all cables carefully so that they are not exposed to excessive pressure. Chapter 6. Service replaceable units 71