IBM 8835 Hardware Maintenance Manual - Page 69
CD-ROM, drive
UPC - 000435158314
View all IBM 8835 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
CD-ROM drive Complete the following steps to remove the CD-ROM drive. Note: v Read "Installation guidelines" on page 25. v Read the safety notices at "Safety information" on page 101. v Read "Handling static-sensitive devices" on page 25. 1. Turn off the server and all attached devices. 2. Disconnect all power cords and external cables from the back of the server. 3. Remove the server from the rack. 4. Remove the server cover (see "Removing the cover and bezel" on page 27); then, take out the air baffle. 5. Remove the four microprocessor fans, making note of their orientation for later replacement. 6. Disconnect the CD-ROM drive power cable from the system board. 7. Disconnect the IDE cable from the CD-ROM drive. 8. Press the release cam until the media tray protrudes slightly from the front of the server. Note: The illustrations in this publication might differ slightly from your hardware. Release cam Holes Interposer card Media tray CD-ROM disk drive Retainer wire Retention tab 9. Carefully pull the drive assembly out of the chassis. 10. Remove the retaining wires on the drive assembly. 11. To remove the CD-ROM drive from the media tray, pull gently on the drive and slide it out of the tray. 12. To remove the interposer card, remove the screw that secures it to the media tray and pull the card away from the media tray. To replace the CD-ROM drive, reverse the previous steps. Chapter 6. Service replaceable units 59