IBM 8835 Hardware Maintenance Manual - Page 68
Operator, information
UPC - 000435158314
View all IBM 8835 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Operator information card Complete the following steps to remove the operator information card. This component is located in the front of the server. Note: v Read "Installation guidelines" on page 25. v Read the safety notices at "Safety information" on page 101. v Read "Handling static-sensitive devices" on page 25. 1. Turn off the server. 2. Disconnect all power cords and external cables from the back of the server; then, remove the server from the rack. 3. Remove the server cover and bezel (see "Removing the cover and bezel" on page 27). 4. Remove the hard disk drive that is in the right-hand bay, if any (see "Working with a hard disk drive" on page 34). 5. Disconnect the operator information card cables from the system board. Note: The illustrations in this publication might differ slightly from your hardware. Tabs Operator information card 6. Gently pull the operator information card forward until it disengages from the two tabs on the chassis, making sure that any cables that are pulled slide smoothly. 7. Disconnect the cables from the rear of the operator information card. To replace the operator information card, connect the two cables to the rear of the card and slide it under the tabs on the chassis until it is firmly anchored. 58 325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide Eserver