IBM 8863 Service Guide - Page 87
until
UPC - 000435474667
View all IBM 8863 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8863," on page 93 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. Error code Description Action 166-400-000 ISMP Self Test Result failed tests: xxx where xxx=flash, ROM, or RAM. 1. Disconnect all server and option power cords from the server, wait 30 seconds, reconnect the power cords, and retry. 2. Update the BMC firmware (see "Updating the firmware" on page 133). 3. Reseat the I/O board. 4. Replace the I/O board. 166-400-100 DMC Self Test Result failed tests: xxx where 1. Disconnect all server and option power cords xxx=flash, ROM, or RAM. from the server, wait 30 seconds, reconnect the power cords, and retry. 2. Update the BIOS code, BMC, service processor, and diagnostics firmware (see "Updating the firmware" on page 133). 180-197-000 SCSI ASPI driver not installed. 1. Remove the RAID adapter, if one is installed, and run the test again. 2. Reseat the following components: a. SAS hard disk drive backplane cables b. I/O board c. Microprocessor tray 3. Replace the following components one at a time, in the order shown, restarting the server each time. a. SAS hard disk drive backplane b. I/O board c. (Trained service technician only) Microprocessor tray 180-361-003 Failed fan LED test. 1. Reseat the following components: a. Fan b. I/O board 2. Replace the components listed above one at a time, in the order listed above, restarting the server each time. 180-xxx-000 Diagnostics LED failure. Run the diagnostic LED test for the failing LED. Chapter 2. Diagnostics 71