IBM 8863 Service Guide - Page 89
programming
UPC - 000435474667
View all IBM 8863 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8863," on page 93 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. Error code Description Action 180-xxx-006 Failed memory card LED test. 1. Reseat the following components: a. Memory card b. Microprocessor tray c. I/O board 2. Replace the following components one at a time, in the order shown, restarting the server each time. a. Memory card b. (Trained service technician only) Microprocessor tray c. I/O board 180-xxx-007 Failed power supply fan LED test. 1. Reseat the following components: a. Power supply b. (Trained service technician only) Power supply structure c. I/O board 2. Replace the components listed in step 1 one at a time, in the order shown, restarting the server each time. 180-xxx-008 Failed I/O board LED test. 1. Reseat the I/O board. 2. Replace the I/O board. 180-xxx-009 Failed Active™ PCI LED test. 1. Reseat the following components: a. (Trained service technician only) PCI-X switch card assembly b. I/O board 2. Replace the components listed in step 1 one at a time, in the order shown, restarting the server each time. 201-198-000 Memory Test Aborted: Could not run the test; suspect microprocessor tray error. 1. Restart the server. 2. Run the diagnostic test again. 3. Reinstall the diagnostic programs (see "Updating the firmware" on page 133). 4. (Trained service technician only) Replace the microprocessor tray. 201-198-00n Memory Test Aborted: Could not run the test. Note: n = 1-9 (programming error). 1. Restart the server. 2. Run the diagnostic test again. 3. Reinstall the diagnostic programs (see "Updating the firmware" on page 133). Chapter 2. Diagnostics 73