IBM 8863 Service Guide - Page 99
IBM 8863 - eServer xSeries 366 Manual
UPC - 000435474667
View all IBM 8863 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8863," on page 93 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. System-error log message Action IB MR Reg 1.8V Power Good Fault 1. Reseat the microprocessor tray. 2. Reseat the memory cards. 3. (Trained service technician only) Replace the microprocessor tray. Invalid CPU configuration Make sure that the microprocessors have been installed in the correct order (see "Removing and installing a microprocessor" on page 124). Invalid Fan configuration Replace any missing or failed fans. IP address of default gateway modified from x.x.x.x Information only IP address of network interface modified from x.x.x.x Information only IP subnet mask of network interface modified from x.x.x.x Information only Loader Watchdog Triggered 1. Reconfigure the loader watchdog timer to be a higher value (twice the normal operating-system boot time). 2. Install the Remote Supervisor Adapter II SlimLine device driver for the operating system. 3. Disable the loader watchdog. 4. Check the integrity of the installed operating system. 5. Reinstall the operating system with the applicable device drivers. Machine check asserted - SPINT, North Bridge Information only, Just an indication of who reported the SPINT first. Machine check asserted - SPINT, PCI Bridge A Information only. Just an indication of who reported the SPINT first. Machine check asserted - SPINT, PCI Bridge B Information only. Just an indication of who reported the SPINT first. Machine check asserted - SPINT, Remote CheckStop Information only. Just an indication of who reported the SPINT first. Machine check asserted for Card or Link SPINT, Remote Node, Link 1 Information only. The machine check was reported by the node connected to scalability port 1. Machine check asserted for Card or Link SPINT, Remote Node, Link 2 Information only. The machine check was reported by the node connected to scalability port 2. Machine check asserted for Card or Link SPINT, Remote Node, Link 3 Information only. The machine check was reported by the node connected to scalability port 3. Machine check asserted for Card or Link SPINT, Scalability 1. Reseat the scalability cables and microprocessor board. 2. Replace the scalability cables 3. Replace the scalability cartridge assembly. 4. Replace the microprocessor board. Machine check asserted for Card or Link SPINT, Quad Bus A 1. Reseat microprocessor 1 and 2. 2. Replace microprocessor 1 or 2. 3. Replace the microprocessor board. Chapter 2. Diagnostics 83