IBM HS20 Hardware Maintenance Manual - Page 81
POST error codes, Run the Configuration/Setup Utility program.
UPC - 087944983033
View all IBM HS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Note: See "System" on page 94 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 405-XXX-000 (Failed Ethernet test on controller on the system board) 1. Verify that Ethernet is not disabled in BIOS. 2. System board. POST error codes In the following error codes, X can be any number or letter. Note: See "System" on page 94 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 062 (Three consecutive startup failures using the default configuration.) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. System board. 4. Microprocessor. 101, 102 (System and processor error) v System board 106 (System and processor error) v System board 111 (Channel check error) 1. Failing adapter 2. DIMM 3. System board 114 (Adapter read-only memory error) 1. Failing adapter. 2. Run diagnostics. 151 (Real time clock error) 1. Run diagnostics. 2. Battery. 3. System board. 161 (Real time clock battery error) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. System board. 162 (Device configuration error) Note: Be sure to load the default settings and any additional desired settings; then, save the configuration. 1. Run the Configuration/Setup Utility program. Note: If unable to enter Configuration/Setup Utility program, view system event log in BladeCenter management module. 2. Battery. 3. Failing device. 4. System board. 163 (Real-time clock error) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. System board. 164 (Memory configuration changed.) 1. Run the Configuration/Setup Utility program. 2. DIMM. 3. System board. 165 (Service Processor failure) v System board Chapter 8. Symptom-to-FRU index 71