IBM HS40 Hardware Maintenance Manual - Page 52
Removing, blade, server, bezel, assembly
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Removing the blade server bezel assembly To install certain options, you must first remove the blade server bezel assembly. Complete the following steps to remove the blade server bezel assembly: 1. Review the safety information beginning on page 109 and "Installation guidelines" on page 33. 2. Open the blade server cover (see "Opening the blade server cover" on page 40 for instructions), and lift it off the blade server. 3. Press the bezel-assembly release, and rotate the bezel assembly away from the blade server chassis; then, unhook the tabs on the bottom of the bezel from the holes on the server chassis, and remove the bezel. Bezel-assembly release Bezel-assembly release 4. Disconnect the control-panel cable from the control-panel connector. Control-panel connector Control-panel cable 5. Pull the bezel assembly away from the blade server. 6. Store the bezel assembly in a safe place. 42 BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide