IBM HS40 Hardware Maintenance Manual - Page 89
error, codes
![]() |
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
POST error codes The following table lists error codes that might be sent to the management module for error logging as BMC pass-through error entries for the management module system-error log (SEL). Note: The syntax of error logging between the management module and the SEL might be different. Local SEL error codes might differ from the SEL entries logged by the management module for identical event types. In the following error codes, X can be any number or letter. Note: See Chapter 7, "Parts listing, Type 8839," on page 105 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 0000 (Timer error) 1. Run diagnostics. 2. Battery. 3. I/O board. 0005 (CMOS checksum bad loading defaults) Information only; no action required. 0012 (CMOS date/time not set) Run the Configuration/Setup Utility program, and set the date and time. 0040 (Refresh timer test failed) 1. I/O board 2. Processor board 0044 (DMA controller error) I/O board 0045 (DMA-1 error) I/O board 0046 (DMA-2 error) I/O board 004C (Keyboard/interface error) I/O board 004D (Primary master hard disk error) 1. Reset primary hard disk. 2. Run diagnostics. 3. Primary hard disk. 4. I/O board. 004F (Secondary master hard disk error) 1. Reset secondary hard disk. 2. Run diagnostics. 3. Secondary hard disk. 4. I/O board. 0055 (Primary master drive - ATAPI incompatible) Primary master hard disk drive 0057 (Secondary master drive - ATAPI incompatible) Secondary master hard disk drive 005D ATA drive (ATA SMART failure error (dynamic string)) Chapter 6. Symptom-to-FRU index 79
![](/manual_guide/products/ibm-hs40-hardware-maintenance-manual-da5f456/89.png)