IBM HS40 User Guide - Page 36
Removing, blade, server, BladeCenter
![]() |
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
v Do not leave the device where others can handle and possibly damage the device. v While the device is still in its static-protective package, touch it to an unpainted metal part of the BladeCenter unit or any unpainted metal surface on any other grounded rack component in the rack you are installing the device in for at least 2 seconds. This drains static electricity from the package and from your body. v Remove the device from its package and install it directly into your blade server without setting it down. If it is necessary to set the device down, place it in its static-protective package. Do not place the device on your blade server cover or on a metal table. v Take additional care when handling devices during cold weather. Heating reduces indoor humidity and increases static electricity. Removing the blade server from the BladeCenter unit The following illustration shows how to remove the blade server from the BladeCenter unit. Notes: 1. The illustrations in this document might differ slightly from your hardware. 2. Unless otherwise stated, references to the BladeCenter unit also apply to the BladeCenter T unit. Type 8677 22 BladeCenter HS40 Type 8839: Installation and User's Guide
![](/manual_guide/products/ibm-hs40-user-guide-5a9fb4f/36.png)