IBM HS40 User Guide - Page 57
equivalent
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Note: After you replace the battery, you must reconfigure your blade server and reset the system date and time. Statement 2: CAUTION: When replacing the lithium battery, use only IBM Part Number 16G8095 or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of. Do not: v Throw or immerse into water v Heat to more than 100°C (212°F) v Repair or disassemble Dispose of the battery as required by local ordinances or regulations. Complete the following steps to replace the battery: 1. Read the safety information beginning on page vii and "Installation guidelines" on page 21. 2. Follow any special handling and installation instructions supplied with the battery. 3. Turn off the blade server and remove the blade from the BladeCenter unit (see "Removing the blade server from the BladeCenter unit" on page 22 for instructions). 4. Open the blade server cover (see "Opening the blade server cover" on page 24 for instructions) and lift it off the blade server. 5. Locate the battery on the I/O board. Battery 6. Remove the battery: Chapter 3. Installing options 43